Weld Blog

Process · GTAW

TIG welding explained

TIG welding makes the arc from a tungsten electrode that does not melt. You add filler rod by hand with the other hand, and often control the heat with a foot pedal. It is slow to learn and gives the most control.

What melts in
Tungsten that does not melt, plus a filler rod fed by hand
Shielding
Bottled argon
Current
DC for steel, AC for aluminum
Slag
None
In wind
Poor: needs still air

How TIG works

The TIG torch holds a sharpened tungsten electrode inside a ceramic or glass cup. Argon flows out of the cup and around the arc. When the arc forms, it melts a small puddle in the base metal. If the joint needs filler, you dip a bare filler rod into the front edge of the puddle with your free hand. The tungsten itself is not meant to touch the puddle or melt. The formal name is gas tungsten arc welding, or GTAW.

DC for steel, AC for aluminum

Steel, stainless steel and copper are welded on DC electrode negative. Aluminum and magnesium are usually welded on AC. Aluminum is covered in a tough oxide layer that melts at above 2,000°C (about 3,700°F), while the aluminum under it melts at about 660°C (1,220°F). The AC arc breaks up that oxide on every half cycle so the puddle can form. A TIG machine that welds aluminum must offer AC output, and the manual explains its AC settings.

The tungsten

Tungstens come in several types, each marked with a color band at one end. Their composition decides how well they start and hold an arc on AC or DC. Thoriated types are slightly radioactive, so many welders now use other types, and anyone grinding thoriated tungsten should control the dust. For DC work the tungsten is usually ground to a point, with the grinding marks running lengthwise toward the tip. Dip the tungsten in the puddle and it gets contaminated: stop, break off or grind away the dirty end and re-sharpen it.

A first TIG bead

  1. Clean the metal and the filler rod well. On aluminum, use a stainless brush kept only for aluminum and wipe with a suitable solvent that leaves no residue. TIG shows every bit of dirt.
  2. Set the argon flow to what the manual suggests and keep the post-flow on, so gas protects the hot tungsten and weld after the arc stops.
  3. Hold the torch at a slight angle, about 10 to 15 degrees back from straight up, with the tungsten a short distance from the work.
  4. Start the arc and hold it until a shiny puddle forms.
  5. Dab filler into the front edge of the puddle, pull it back while staying inside the gas cover, move the torch forward, and repeat with a steady rhythm.

With a foot pedal, you press for more heat as the puddle forms and ease off as the part heats up or as you reach the end of the joint.

Strengths and trade-offs

TIG gives the cleanest, most precise welds, with no spatter or slag. It handles thin metal, stainless steel and aluminum well and is the usual choice where a weld will be seen. The trade-offs: it is slow, it needs clean metal and still air, and coordinating torch, filler and pedal takes many hours to feel natural. Many people learn MIG or stick first and come to TIG with good puddle-reading habits.

The TIG arc is quiet and steady, which makes it easy to forget how much ultraviolet light it gives off. Cover all exposed skin. See safety gear.

TIG questions

What does TIG stand for?

Tungsten inert gas. The shielding gas is usually pure argon. The formal name is gas tungsten arc welding (GTAW).

Do I always need filler rod?

No. On thin edges and some joints the base metals can be melted together on their own. This is called fusion or autogenous welding. Most joints need filler to fill the gap and build the weld up to size.